The Installation Method and Disassembly Details of the Embedded Ceiling Lamp

When it comes to the installation of embedded ceiling lights, you must be familiar with them. The living room and bedroom are common places where ceiling lights are installed. The most obvious thing about the installation of embedded ceiling lights in these places is their decorative effect. You should know that the living room is also a place where we entertain guests, and a bedroom is a place where we sleep, which is a very important place, so the decoration cannot be ignored. Do you know the installation method of an embedded ceiling lamp, or have you installed it yourself?

Installation method of embedded ceiling lamp

1. According to the device position of the embedded ceiling lamp to be installed, a square hole or round hole shall be opened at the ceiling device of the embedded ceiling lamp to be installed. The area of the attention hole shall be equal to the embedded ceiling lamp, and the position of the lamp device must be determined to facilitate the installation of the embedded ceiling lamp.

2. When installing the device, first install the device cartridge on both ends of the lamp, and then install the cartridge on both ends of the lamp and the lamp in the square hole or round hole.

3. Connect the power line, cover the wiring cover and screw it down. The number of bolts for fixing the lamp base should not be less than the number of fixing holes on the lamp base, and the bolt diameter should match the hole diameter; Lamps without fixing holes on the base. If there is no fixing device hole on the base, it can be fixed by drilling holes on its own. Each lamp should have at least 3 bolts or screws for fixing, and the center of gravity of the lamp should match the center of gravity of the bolts or screws.

4. Place the lamp and fix it. Press the snap ring at both ends of the lamp and put it into the opening of the ceiling. The snap ring on the inside of the lamp is against the ceiling. Press the mask with your hand and push it upward slightly to fasten it.

Removal method of embedded ceiling lamp

The ceiling lamp is usually directly fixed to the ceiling or ceiling during interior decoration. The nut fixing is not visible outside, so it needs to be messy when disassembling. Generally, two spring sheets are fixed on the back of the embedded ceiling lamp. When disassembling, you need to grasp the two frames with your hands and pull them down gradually. You should also drag the ceiling lamp together.

We are a double recessed ceiling lights exporter supplier wholesaler, our products satisfy our customers. And we want to be your long-term partner, any interests, welcome to contact us.